About hinted handoff writes
How hinted handoff works and how it optimizes the cluster.
Hinted handoff is a Cassandra feature that ensures high write availability when consistency is not required. Hinted handoff dramatically improves response consistency after temporary outages such as network failures. You enable or disable hinted handoff in the cassandra.yaml file.
How hinted handoff works¶
When a write is performed and a replica node for the row is either known to be down ahead of time, or does not respond to the write request, the coordinator will store a hint locally in the system.hints table. This hint indicates that the write needs to be replayed to the unavailable node(s).
The hint consists of:
- The location of the replica that is down
- The row that requires a replay
- The actual data being written
By default, hints are saved for three hours after a replica fails because if the replica is down longer than that, it is likely permanently dead. In this case, run a repair to re-replicate the data before the failure occurred. You can configure this interval of time using the max_hint_window_in_ms property in the cassandra.yaml file.
After a node discovers from gossip that a node for which it holds hints has recovered, the node sends the data row corresponding to each hint to the target. Additionally, the node checks every ten minutes for any hints for writes that timed out during an outage too brief for the failure detector to notice through gossip.
A hinted write does not count toward consistency level requirements of ONE, QUORUM, or ALL. The coordinator node stores hints for dead replicas regardless of consistency level unless hinted handoff is disabled. If insufficient replica targets are alive to satisfy a requested consistency level, an UnavailableException is thrown with or without hinted handoff. This is an important difference from Dynamo’s replication model; Cassandra does not default to sloppy quorum.
For example, in a cluster of two nodes, A and B, having a replication factor (RF) of 1: each row is stored on one node. Suppose node A is down while we write row K to it with consistency level of one. The write fails because reads always reflect the most recent write when:
W-nodes + R > replication factor
where W is the number of nodes to block for writes and R is the number of nodes to block for reads. Cassandra does not write a hint to B and call the write good because Cassandra cannot read the data at any consistency level until A comes back up and B forwards the data to A. For more information about how hinted handoff works, see "Modern hinted handoff" by Jonathan Ellis.
Extreme write availability¶
For applications that want Cassandra to accept writes even when all the normal replicas are down, when not even consistency level ONE can be satisfied, Cassandra provides consistency level ANY. ANY guarantees that the write is durable and will be readable after an appropriate replica target becomes available and receives the hint replay.
By design, hinted handoff inherently forces Cassandra to continue performing the same number of writes even when the cluster is operating at reduced capacity. Pushing your cluster to maximum capacity with no allowance for failures is a bad idea. Hinted handoff is designed to minimize the extra load on the cluster.
All hints for a given replica are stored under a single partition key , so replaying hints is a simple sequential read with minimal performance impact.
If a replica node is overloaded or unavailable, and the failure detector has not yet marked it down, then expect most or all writes to that node to fail after the timeout triggered by write_request_timeout_in_ms, which defaults to 10 seconds. During that time, Cassandra writes the hint when the timeout is reached.
If this happens on many nodes at once this could become substantial memory pressure on the coordinator. So the coordinator tracks how many hints it is currently writing, and if this number gets too high it will temporarily refuse writes (withUnavailableException) whose replicas include the misbehaving nodes.
Removal of hints¶
When removing a node from the cluster by decommissioning the node or by using the nodetool removenode command, Cassandra automatically removes hints targeting the node that no longer exists. Cassandra also removes hints for dropped tables.
Scheduling repair weekly¶
- Loss of historical data about which writes have finished. The is no information about what data has gone missing to convey to the rest of the cluster.
- Loss of hints-not-yet-replayed from requests that the failed node coordinated.
Attention: Be sure this document version matches your product version